White Papers

Table Of Contents

Document 499

MetricId

All the user to select all metrics with the corresponding matched ID to add

to the report. All selection criteria here and below are considered (“AND”-

ed) together to select metrics.

MetricProperties

Array of URIs of properties included in this metric. This property is not

implemented.

OEM/Dell/Source

Allows you to to specify the data source to include.

This is logically “AND”-ed with the metric id and FQDD, if specified. It can

be specified by itself to request all MetricIds from that source be included.

OEM/Dell/FQDD

Allows you to to specify an FQDD filter.

This is logically “AND”-ed with all other selection criteria. It can be specified

by itself to request all MetricIds that are reported for that FQDD.

OEM/Dell/CustomLabel

The value of the customLabel field is used as the label for that metric in the

metric report and overrides the default label.

Read Only Properties

AppendLimit – This value is a read only value that is determined by the Telemetry Service, and will be

added as output to any Metric Report Definition. This parameter represents the maximum number of metrics

in a report. The default value is 2400.

Status – This read-only property reflects the current state of the report definition. Values are “Enabled” or

“Disabled” and reflect the MetricReportDefinitionEnabled value. If the report is “AppendStopsWhenFull”,

then this is updated to “Disabled” as well as the MetricReportDefinitionEnabled property.

Read only OEM attributes are listed below.

OEM/Dell/Digest – The attribute allows you to Identify out of band changes in custom MRD outside the

influence of the component that created it. Digest represent a consistent hash of the editable fields in metric

report definition and remain constant if the definition remains intact. Digest changes with updates in the

report definition. Digest also change with firmware updates if the updated version includes changes to

editable metric report definition fields.

OEM/Dell/iDRACFirmwareVersion – Represents the current installed version of the iDRAC firmware.