Owners Manual

EqualLogic FS7500 Controller Hardware Maintenance Installing System Components
2–15
Figure 2-11: Bundled Signal and Power Cables
Figure 2-12 shows the back panel of the FS7500 controller with the bundled cords secured to the
rails.
Figure 2-12: Securing the Signal and Power Cable Bundles
Steps for Managing Cables Using a Service Loop
A service loop is an extra length of cable between the rear of the rack and the controller. Using a
service loop allows you to extend the controller forward on its rails for servicing without needing
to disconnect all of the network and power cables from the back panel of the controller.
Note: Servicing a controller installed with a service loop requires at least two individuals one at
the front of the rack and one at the back.
The procedure to install a service loop consists of the following steps: