Owners Manual

EqualLogic FS7500 Controller Hardware Maintenance Installing System Components
2–13
Figure 2-9: Looping the Power Cables Through the Strain Relief Straps
Bundling the Network and Power Cables
Using the hook-and-loop fasteners provided in the shipping box, bundle the cables together as
follows:
1. Use a hook-and-loop fastener to bundle the network cords together and route the bundle
toward the left side of the controller back panel.
2.
Use a hook-and-loop fastener to bundle together the two power cables and route them toward
the right side of the controller back panel.
Securing the Network and Power Cable Bundles to the Rails
The FS7500 controller rails have brackets attached to the rear of each rail. These brackets extend
beyond the back of the system when the rails are installed. Figure 2-10 shows the location of the
hook-and-loop fasteners on the brackets.