Install Guide

For complete information about accessing CIFS shares, and setting ACLs or SLPs on a CIFS share, see the Dell

EqualLogic Group Manager Administrator's Manual and the online help available from the Group Manager GUI

interface.

Accessing an NFS Export

If you plan to use NFS over TCP, set up the firewall first:

1. Adjust the firewall to allow the FS7600 controllers to be the source IP.

2. Open the firewall to allow for port ranges.

To mount an NFS export on a UNIX system, log in as root and run the mount command with the following

recommended options and parameters:

mount -o rw,bg,hard,nointr,tcp,vers=3,timeo=2,retrans=10,rsize=32768,

wsize=32768 client_access_vip:hostname:/container_name /exported_directory /local_directory

The exported_directory must be the full path name that you specified when creating the NFS export.

Because the default trusted user setting is “All except root,” only users other than root can access the export.

You can modify the export and change the trusted users to “Nobody” or “All.”

In addition:

• The default client access permission provides access to all clients. You can modify the export and limit

access to specific IP addresses.

• The default access type is read-write. You can modify the export and change it to read-only.

For complete information about accessing an NFS export, see the Dell EqualLogic Group Manager

Administrator's Manual and the online help available from the Group Manager GUI interface.

Dell EqualLogic FS7600 Installation and Setup Guide 6 NAS Storage Allocation