Users Guide
• Create an Exchange Smart Copy for the group named MyMailboxDatabase and run Checksum Verification and Soft Recovery during
the Global Verification window. This command specifies a value for the ‑scheduleID= parameter:
> ASMCLI -smart -scheduleID="00000000‑1111‑2222‑3333‑00000000"
-component="MyMailboxDatabase" -shadowType=Transportable -backupType=copy
-snapshotType=Snapshot -keepCount=14 -checksum -recovery ‑offpeak
• Create an Exchange Smart Copy for MyMailboxDatabase and perform Checksum Verification and Soft Recovery during the Global
Verification window:
> ASMCLI -smart ‑component="MyMailboxDatabase" -shadowType=Transportable
-backupType=copy -snapshotType=Snapshot
-keepCount=1 -checksum -recovery -offpeak
• Create a clone of a volume specifying the LocationRoot parameter:
> ASMCLI -smart -email -objectid="Psv{18a09060-1d50-f672-69fb-d412bc01209b;1048576}"
-comment=clone of kvol1--@ -shadowtype=transportable
-backuptype=Copy -smartcopytype=Clone
-locationroot="C:\ProgramData\EqualLogic\Mounts\"
ASMCLI -unmount
Specify the ‑unmount subcommand to unmount and log off a volume.
Use optional parameters to unmount multiple volumes and control the selection of volumes, and the Smart Copy version. You can
optionally delete the Smart Copy on successful completion of the operation.
This command will fail on a cluster if:
• The target is the cluster quorum disk
• The target is a physical disk resource that has not been placed in maintenance mode
• The target is a physical disk resource that is not owned by this node
Command Syntax
ASMCLI ‑unmount
[{-document="path"|
-volume={"drive_letter" |"mount_point"}|
-component="component_name" |
-collection="collection_name"|
-writer="writer_name" |
-objectID="identifier"}]
-location="[drive_letterA;drive_letterB;...| mount_point;...]"}|
-ignorelogoutfail [{-useLatest | -useEarliest}] [-email | -noemail]
-retry=n
-deletesnap -unmountonly
For a description of these parameters, see Command Parameters.
Examples
• Unmount all of the volumes mounted from backup document named e2b3‑f1a3‑234.bcd:
> ASMCLI -unmount -document="PSV{18A09060‑ 3BE0‑3FA8‑0A7A‑E4120000E045;32256}\
e2b3‑f1a3‑234.bcd"
• Unmount the volume mounted from backup document e2b3‑f1a3‑234.bcd. The location of the mount point is D:\TestServer:
> ASMCLI -unmount ‑location="D:\TestServer"
• Unmount the volume from the Smart Copy backup document e2b3‑f1a3‑234.bcd that was mounted at drive E:\
> ASMCLI -unmount -location=E:\
Using the Command Line Interface
121