Owners Manual
Table Of Contents
- Preface
- 1 Basic Array Information
- 2 Maintaining Disks
- 3 Maintaining Control Modules
- Supported Control Modules
- Interpreting Control Module LEDs
- Control Module Handling Requirements
- Identifying Control Module Failures
- Understanding Failover Behavior
- Maintaining Control Module Firmware
- Connecting Network Cables
- Removing a Control Module
- Installing a Control Module
- Replacing the Compact Flash Card
- 4 Maintaining Power Supply and Cooling Modules
- A Environmental, Power, and Other Specifications
- Index
PS3000 Series Hardware Maintenance Preface
viii
Regulatory Agency Notices
PS Series arrays have been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC rules and other international
standards. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, which the user will be required to
correct at his or her own expense.
Regulatory Agency Notes
Service Note
Disconnect all PS Series storage array power cables before
servicing to avoid electric shock.
There is a danger of explosion if a PS Series storage array control
module cache battery is incorrectly replaced. Replace a battery only
with the same or equivalent battery, as recommended by the
manufacturer, and use the instructions in this document. Discard
used batteries according to the manufacturer’s instructions.