Setup Guide

PS Series 3000 QuickStart Step 2. Configure the Array and Create a Group
17
B. Using the serial connection you established in Step 1-F on page 15, press the
key. At the login prompt, enter the
grpadmin account name and the
factory-set password, which is also
grpadmin. Note that passwords are not
echoed on the screen.
C. If you respond by typing y and pressing the key, the following dialog
appears. You can also enter
n and, at a later time, type setup at the console
prompt (>). The utility prompts for the member and group configuration.
Press the key to accept a default value. Enter ? to obtain help.
Group Configuration
Prompt Description
Group name Name of the group (up to 54 characters). Valid characters include
letters, number, and dashes. The first character must be a letter or
number. Identifies the group for the purposes of adding new
members or setting up replication.
Group IP
address
Network address for the group. The group IP address is used for
group administration and host access to data stored in the group.
Password for
managing group
membership
Password required when adding members to the group. The
password must have 3 to 16 alphanumeric characters and is
case-sensitive.
Password for the
default group
administration
account
Password that will override the factory-set password (
grpadmin)
for the default
grpadmin account. The password must have 3 to
16 alphanumeric characters and is case-sensitive.
Login: grpadmin
Password: grpadmin
Welcome to Group Manager
Copyright 2001-2006 EqualLogic, Inc.
It appears that the storage array has not been configured.
Would you like to configure the array now? (y/n) [n] y