Setup Guide
Table Of Contents
- Preface
- Introduction to PS Series Storage Arrays
- Steps for Setting Up and Using an Array
- Step 1. Set Up the Array Hardware
- Step 2. Configure the Array and Create a Group
- Step 3. Set the RAID Policy
- Step 4. Create a Volume
- Step 5. Connect to the Volume from a Host System
- Advanced Operations and More Information
- Index
PS Series 3000 QuickStart Step 3. Set the RAID Policy
20
If you place the mouse over the unconfigured member, the following pop-up is
displayed, indicating a normal health status.
Not Configured Pop-Up
To set the RAID policy for the member, expand
Members in the far left panel and
select the member name. The following warning appears.
Warning RAID Not Configured
Click
Yes and the Configure Member – General Settings dialog box appears.
Configure Member – General Settings