Setup Guide
Table Of Contents
- Preface
- Introduction to PS Series Storage Arrays
- Steps for Setting Up and Using an Array
- Step 1. Set Up the Array Hardware
- Step 2. Configure the Array and Create a Group
- Step 3. Set the RAID Policy
- Step 4. Create a Volume
- Step 5. Connect to the Volume from a Host System
- Advanced Operations and More Information
- Index
PS Series 3000 QuickStart Step 4. Create a Volume
27
Create Volume – General Settings
Click
Next to display the Create Volume – iSCSI Access dialog box. Specify the
IP address, CHAP user name, or iSCSI initiator name to which the volume will be
restricted. In the following dialog box, volume access is restricted to IP address
172.17.1.40. You can set up more access controls after creating the volume.
Create Volume – iSCSI Access