Owners Manual

PS3000 Series Hardware Maintenance Maintaining Control Modules
3–10
Figure 3-8: Installing a Control Module
After installing a control module, connect network cables to the control module,
as described in Connecting Network Cables on page 3-5. Then, if the array was
shut down, turn on power to the array.
Check the LEDs, as described in Interpreting Control Module LEDs on page 3-2.
Also, check the GUI Member Controllers window or invoke the CLI
member
select show controllers
command. The control module status will be
either
active (if there is only one control module) or secondary.
If two control modules are installed but only one appears in the GUI or CLI, the
control module may not be properly installed. Re-seat the control module. If both
control modules still do not appear in the GUI or CLI, they may not be running the
same firmware, and you should contact your PS Series array service provider.