Setup Guide

PS Series 3000 QuickStart Step 3. Set the RAID Policy

• raid10-nospares — Striping on top of multiple RAID 1 sets, with no

spares, if possible. This policy should be used only at installations where extra

disks and personnel are available at all times to replace failed disks.

Note: This option is available only with the CLI.

•

raid50-nospares — Striping on top of two RAID 5 sets, with no spares,

if possible. This policy should be used only at installations where extra disks

and personnel are available at all times to replace failed disks.

Note: This option is available only with the CLI.

For example, the following command specifies a RAID policy of RAID-50 for a

member:

> member select member01 raid-policy raid50