Owners Manual

PS3000 Series Hardware Maintenance Maintaining Control Modules
3–12
• You can access the compact flash card by sliding the control module partially
from the slot. If you completely remove the control module, place it on a
surface that is protected from electrostatic discharge.
Figure 3-9 on page 3-12 shows how to remove a compact flash card from a
control module and also how to install a card.
After you replace the compact flash card, see Installing a Control Module on
page 3-9 for instructions on installing a control module.
Figure 3-9: Removing and Installing a Compact Flash Card
After installing the control module, if the array was shut down, turn on power.
To ensure that the control module is operational, check the LEDs, as described in
Interpreting Control Module LEDs on page 3-2. Also, check the GUI Member
Controllers window or invoke the CLI
member select show controllers
command. The control module status will be either
active or secondary.