Setup Guide

PS Series 3000 QuickStart Step 1. Set Up the Array Hardware
3
Step 1. Set Up the Array Hardware
A. Unpack Shipping Box and Gather Hardware
The order in which you unpack the shipping box is important for safety:
1. Open the outer shipping box and remove the accessory box.
2. Remove the accessories and ensure that you have the contents shown in the
figure Shipping Box Contents.
3. Following the unpacking instructions in the shipping box, lift the array and
place it on a flat surface that is protected from electrostatic discharge. Do not
remove the plastic bag from the array until you are ready to install it in a rack.
4. Gather the hardware that is not included in the box, as described in the table
Required Hardware – Not Supplied.
Shipping Box Contents
The array is heavy. Do not attempt to lift or install the array without
assistance.