Install Guide

Installation and Setup Guide 2 Rack Mounting the Array

Attach the Chassis to the Mounting Rails

Make sure the chassis captive fasteners on the front of the array line up with the threaded holes on the front of

the mounting rails, and manually secure the captive fasteners to the rails.

Caution: Do not use an automatic driver to tighten the thumbscrews.

Installing the Bezel

The steps for installing the bezel are the same for all array models.

1. Hook the right end of the bezel onto the right side of the chassis.

2. Swing the left end of the bezel towards the left side of the chassis.

3. Press the bezel into place until the release latch closes.

4. Using the key provided, lock the bezel and store the key in a safe place.

Figure 4: Installing the Bezel