Install Guide

Installation and Setup Guide 3 Connecting the Array Cables

Figure 5: Recommended Network Configurations

Connect and Secure the Power Cables

Obtain the power cables that were shipped with the array. If the array was not shipped with power cables,

contact your PS Series support provider or reseller for power cable information.

Note: The power supply and cooling modules are different for the 2U and the 4U array models. However, they

function the same way in terms of integration into a datacenter power infrastructure.

1. Make sure that the power switch is in the OFF (O) position before connecting the power cables.

2. Connect the power cables to the power supplies as shown in .

3. Secure the power cables to the system:

a. Secure the power cables firmly to the bracket next to the system power receptacle using the

provided hook-and-loop strap.

b. Make sure the strap is tightly bound to the bracket anchor point (remove any slack).

c. Bias the power cable toward the strap and wrap the strap tightly around the cable against the

shoulder of the power cable connector.

4. Attach the power cables to a power source:

– Plug the power cables into a grounded electrical outlet or a separate power source such as an unin-

terrupted power supply (UPS) or a power distribution unit (PDU).The bottom LED of the power supply

will be illuminated green (indicating power is present) when power cables are connected.