Install Guide

安装和设置指南

4 软件配置

示例 - 使用设置公用程序

Password: xxxxxxxx

The setup utility establishes the initial network and storage configuration for a storage array

and then configures the array

as a member or a new or existing group of arrays.

For help, enter a question mark (?) at a prompt.

Welcome to Group Manager

It appears that the storage array has not been configured.

Would you like to configure the array now? (y/n) [n] y

Group Manager Setup Utility

Do you want to proceed (yes | no) [no]? yes

Initializing. This may take several minutes to complete.

Enter the network configuration for the array:

Member name []: member1

Network interface [eth0]: eth0

IP address for network interface []: 192.17.2.41

Netmask [255.255.255.0]:

Default gateway [192.17.2.1]:

Enter the name and IP address of the group that the array will join.

Group name []: group1

Group IP address []: 192.17.2.20

Searching to see if the group exists. This may take a few minutes.

The group does not exist or currently cannot be reached. Make sure you have entered the correct

group IP address and group name.

Do you want to create a new group (yes | no) [yes]? yes

Group Configuration

Group Name: group1

Group IP address: 192.17.2.20

Do you want to use the group settings shown above (yes | no) [yes]: yes

Password for managing group membership:

Retype password for verification:

Password for the default group administration account:

Retype password for verification:

Saving the configuration ...

Waiting for configuration to become active......Done

Group member member1 now active in the group.

Group group1 has been created with one member.

Use the Group Manager GUI or CLI to set the RAID policy for the member. You can then create a

volume that a host can connect to using an iSCSI initiator.

group1>

