Owners Manual

PS4210 Hardware Owner's Manual

3 Maintaining Control Modules

Set the screw aside before you remove the cover; otherwise, the screw might fall inside the control module. If

this occurs, you might have to return the control module to Dell for servicing.

4. Using the screw tab as a handle, swing the battery cover up and to the left and lay it upside down on the

control module (Figure 23). The battery cover will be heavier than expected because the battery is attached

to the cover.

Figure 23: Removing the Battery Cover

5. The connector that connects to the battery unit is held in place by a retaining clip, which must be depressed

to remove the connector, as shown in Figure 24. Grasp the outside of the connector, while simultaneously

depressing the retaining clip, and wiggle the connector gently side to side while pulling outward to remove it.

Set the old battery unit aside.

Figure 24: Disconnecting the Battery