Install Guide

PS4210 Installation Guide 2 Rack Mounting the Array
3. Connectthebandtoground.Youcaneitherplugthebananaconnectorintoamatching
groundedreceptacle,orattachittothematchingalligatorclipandconnectthecliptoa
groundeddevice.ExamplesofanappropriategroundwouldbeanESDmatorthemetal
frameofagroundedpieceofequipment.
Shipping Box Contents and Required Hardware
Makesureyouhavealltheitemssuppliedintheshippingbox,describedinTable1.Youmust
provideadditionalhardwarethatisspecifictoyourenvironmentandnotincludedintheshipping
box.SeeTable2.
Table 1: Shipping Box Contents
Component Description
PSSeriesArray
• TwoType19controlmodules
• Twopowersupplyandcoolingmodules
• Upto242.5-inch10Kor123.5-inch7.2Kserial-attachedSCSI(SAS,
NearlineSAS[NL-SAS],orSolidState(SSD)drives,dependingonthe
modelsuffix
Bezel
Thebezelmountstothefrontofthearray.Thebezelidentifiesthearray
modelandprotectsthedrivesfromunauthorizedoraccidentalremoval.
Powercables
Connectsanarraypowersupplytopowersources.Ifpowercablesarenot
includedintheshippingbox,contactyourPSSeriesarraysupportprovideror
reseller.
Oneortwoserial
cables
Createsaserialconnectionbetweenanarrayandaconsoleorterminal
emulator.Usethecabletorunthesetuputilityifthereisnonetworkaccess
tothearrayorgroup.
Documentation
Thefollowingdocumentationisincludedintheshippingbox:
• Setupposter
• InstallationandSetupGuide(thisdocument)
• License,regulatory,andwarrantyinformation
• Safety,Environmental,andRegulatoryInformationbooklet
Table 2: Additional Hardware Required (Not Included)
Component Description
Standard19-in.
four-postrack
Provideseasyaccesstoarraysandotherhardwareinyourcomputing
environment.
10/100Mbps
Ethernetcables
Forusewithadedicatedmanagementnetwork.ConnectstheManagementporton
thearraytoa10/100Mbpsnetworkswitch.UseCategory5EorCategory6cables
withRJ45connectors.UseCategory5cablesonlyiftheymeettheTIA/EIA
TSB95standard.
Networkswitch
Connectsdevices(array)toanetwork.Multipleswitchesarerecommended.
Switchprovides10GBASE-Tinterfacestousethe10GBASE-Tport,oran
SFP+switchtousetheSFP+port.
CAT6orCAT6A
cables
For10GBASE-Tport,useCategory6(orbetter)cableforupto55meters.Use
Category6Acableforupto100meters.
Opticalorcopper
cables
ForSFP+port,useopticalcableorcopperSFP+cable.
5