Install Guide

Optional Hardware
Youcanoptionallyuseanuninterruptiblepowersupplysystem(UPS)toprovideahighly
availablesourceofpowertoanarray.EachUPS(notincluded)shouldbeonadifferentcircuit
andmustprovidethecorrecttypeofvoltageforanadequateamountoftime.
Steps for Mounting an Array in a Rack
Tomountanarrayinarack,followthesesteps:
1. Determinewheretoplacethemountingrailsintherack.
2. Attachthemountingrailstotherack.
3. Slidethechassisintotherack.
4. Attachthechassistothefrontofthemountingrails.
5. Installthebezel.
Thesestepsaredescribedindetailinthefollowingsections.
Determine Where to Place the Mounting Rails in the
Rack
Makesurethereisenoughspaceintherackforthechassis.Inastandardrack,a2Uchassis
willspansixholes.
Installing the Rails and Array in a Rack
Installtherailsintherackfollowingthesafetyinstructionsandtherackinstallationinstructions
providedwithyourrailkit.
Ifinstalledinaclosedormulti-unitrackassembly,theoperatingtemperatureoftherack
environmentmightbegreaterthanroomambient.Therefore,makesureyouinstallthearrayin
anenvironmentcompatiblewiththemaximumtemperaturespecifiedbythemanufacturer.For
moreinformation,seeTechnical Specifications on page 31.
Slide the Array into the Rack
SlidethearrayintotherackasshowninFigure2.
6
PS4210 Installation Guide 2 Rack Mounting the Array