Install Guide

PS4210 Installation Guide 3 Connecting the Array Cables
Figure 6: Recommended Network Configurations
Connect and Secure the Power Cables
Obtainthepowercablesthatwereshippedwiththearray.Ifthearraywasnotshippedwith
powercables,contactyourPSSeriessupportproviderorresellerforpowercableinformation.
1. MakesurethatthepowerswitchisintheOFF(O)positionbeforeconnectingthepower
cables.
2. Connectthepowercablestothepowersuppliesasshownin.
3. Securethepowercablestothesystem:
a. Securethepowercablesfirmlytothebracketnexttothesystempowerreceptacle
usingtheprovidedhook-and-loopstrap.
b. Makesurethestrapistightlyboundtothebracketanchorpoint(removeanyslack).
c. Biasthepowercabletowardthestrapandwrapthestraptightlyaroundthecable
againsttheshoulderofthepowercableconnector.
4. Attachthepowercablestoapowersource:
11