Owners Manual

PS4210 Hardware Owner's Manual

2 Maintaining Drives

Verify that the new drive is operational by examining the LEDs on the front panel, as described in Interpreting

Drive LEDs on page 7. In addition, examine the GUI Member Disks window and the CLI member select show

disks command output.

Removing a Drive Blank

To maintain proper system cooling, all empty drive slots must have drive blanks installed.

1. Remove the bezel. See Removing the Bezel on page 2.

2. Press the release tab and slide the drive blank out until it is free of the drive slot. See Figure 12 or Figure 13

and the callouts in.Table 5.

Figure 12: Removing and Installing a 3.5-Inch Hard-Drive Blank

Figure 13: Removing and Installing a 2.5-Inch Hard-Drive Blank

Table 5: Hard Drive Blank Callout Values

Item Description

1 Drive blank

2 Release tab

Installing a Drive Blank

1. Remove the bezel. See Removing the Bezel on page 2.

2. Insert the drive blank into the drive bay until the blank is fully seated.

3. Attach the bezel.