Install Guide

PS6210 Install and SetupGuide

3 Connecting the Array Cables

Table 4: Power Supply LED Descriptions

Callout Description

PowerSupplystatus.ThisLEDislit(green)whentheswitchisonandthepowersupplyisproviding

powertothearray.

2 Error.ThisLEDislit(amber)ifthepowersupplyhasaproblem.

3 InputPower.ThisLEDislit(green)aslongasmainpowerisconnectedtothepowersupply.

Set Up a Serial Connection to the Array

Ifyouplantousethesetuputilitytoconfigurethesoftware,youmustsetupaserialconnectionbetweenthe

arrayandacomputer.IfyouplantousetheRemoteSetupwizard,youdonotneedaserialconnection.For

informationaboutRemoteSetupwizardrequirements,seetheHost Integration Tool for Microsoft® Installation

and User's GuideortheHost Integration Tool for Linux® Installation and User's Guide.

Theserialcableshippedwiththearrayisastandardnull-modemcablewithafemaleDB9connectoroneach

end.Youmighthavetomakeorbuyanadaptercable(oneDB9connectorandoneRJ45connector)toconnect

thearraytosometerminalservermodels.SeeSerial Cable Pinout Information on page 15.

Attachthecabletotheserialportontheactivecontrolmoduleandtoaconsoleterminaloracomputerrunninga

terminalemulator.TheactivecontrolmodulehastwogreenLEDSandthesecondarycontrolmodulehasone

greenandoneamberLED.

SeeFigure10(nottoscale).

Theserialconnectionmusthavethefollowingcharacteristics:

• 9600baud

• OneSTOPbit

• Noparity

• 8databits

• Noflowcontrol

Note: Keeptheserialcable.Youneedtheserialcabletomanagethegroup,oraspecificarray,ifthereisno

networkaccess.