Users Guide

rswcli --discover Command Syntax

The command syntax is as follows:

rswcli --discover | -d

[--detail]

The following table describes the optional command parameter.

Table 5. Discover Command Parameter

Parameter Description

--detail Specifies whether RSWCLI should output the array MAC address, Host Adapter MAC address,

firmware version, and supported RAID levels for each array. Additional information might display,

depending on your PS Series Array firmware version.

Example: Discovering Uninitialized PS Series Arrays

The following example shows the detailed output of the --discover command.

# rswcli --discover --detail | more

Processing discover command...

Discovering uninitialized PS Series arrays that are accessible from

this computer.

(This could take up to a minute)

1 uninitialized PS Series array found.

Service Tag: JJRKWP1

Serial Number: SHU0935411YBF04

Array MAC Address for eth0: 00:09:8A:0A:4F:30

Host Adapter MAC Address: 00:26:B9:3A:2C:35

Firmware Version: X.Y.Z

Supported RAID Levels: 6, 10, 50

Disk Info: 15 931.52GB 7200rpm SATA(HDD) disks

Product Family: PS6000

The discover command succeeded.

Initializing a PS Series Array

Use the rswcli --initialize (or rswcli -i) command to initialize a PS Series array and join a group.

NOTE:

This command does not support selecting a pool. Use the PS Group Manager GUI or CLI to select a pool when the

member is in a group.

rswcli --initialize Command Syntax

The command syntax is as follows:

rswcli --initialize | -i

--create-group | --cg (or, --jg | --join-group)

--group-ip IPv4_address | -gip

--group-name group-name | --gn

--member-ip-eth0 IPv4_address | --mip

--member-name member-name | --mn

--membership password

--member-subnet subnet_mask | --msub

--member-gateway IPv4_address | --mgwy

--service-tag service-tag | --st

Remote Setup Wizard Command Line Interface