Owners Manual

PS6210 Hardware Owner's Manual 2 Maintaining Drives

Installing a 2.5-inch Drive

The 2.5-inch drives are installed vertically, with the drive release latch on the top and the drive label on

the bottom.

1. Wear electrostatic protection when handling a drive. See Protecting Hardware on page 1.

2. Open the drive release latch.

3. Hold the drive by the carrier and slide the drive most of the way into a slot (callout 1 in Figure 11).

4. Push the drive completely into the slot (callout 2). The drive handle will begin to close onto the

drive (callout 3).

5. Push in the handle until you hear a click (callout 4).

Figure 11: Installing a 2.5-inch Drive

Verify that the new drive is operational by examining the LEDs on the front panel, as described in

Interpreting Drive LEDs on page 7. In addition, examine the GUI Member Disks window and the CLI

member select show disks command output.