Owners Manual

Figure 23: Inserting the MicroSD Card
3. Install the control module in the array. See Installing a Control Module on page 22.
4. Ensure the control module is operational. See Interpreting Control Module LEDs on page 16.
Battery Replacement
This section describes the steps that must be followed when replacing the battery in a PS Series array
control module.
Many repairs may be done only by a certified service technician. You should perform
troubleshooting and simple repairs only as authorized in your product documentation, or as directed
by the online or telephone service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety instructions that came with your
system.
For information on removing and reinstalling system parts, see the system's Hardware Owner's
Manual, available at support.equallogic.com.
Control Module Handling Requirements
Follow these control module handling requirements:
• Do not remove an active control module.
26
PS6210 Hardware Owner's Manual 3 Maintaining Control Modules