Users Guide

> ASMCLI -delete -document="C:\BackupDocs\Shadows\
PSV{11111111‑2222‑3333‑4444‑555555555555}\6666‑7777‑888.bcd"
• Delete the Smart Copy backup document 6666‑7777‑888.bcd.
> ASMCLI -delete document="PSV{11111111‑2222‑3333‑4444‑555555555555\ 6666‑7777‑888.bcd"
• Delete the most recent Smart Copy backup document available for F:\> ASMCLI -delete -volume=F:\ -useLatest
• Delete the oldest Smart Copy backup document available for the Exchange mailbox database named MyMailboxDatabase.
> ASMCLI -delete -component="MyMailboxDatabase" -useEarliest -location="Q:\"
ASMCLI -deleteCollection
The ‑deleteCollection command deletes an existing collection specified by name.
Command Syntax
ASMCLI -deletecollection -collection="collection_name"
For a description of these parameters, see Command Parameters.
Example
Delete the collection called Test Collection:
> ASMCLI -deletecollection -collection="Test Collection"
ASMCLI -enumerateiSCSIPortals
The ‑enumerateiSCSIPortals subcommand enumerates or lists the iSCSI target portals available on the system.
This command outputs a list of iSCSI target portals, the IP address, and error and status information.
Command Syntax
ASMCLI -enumerateiSCSIPortals
Example
Enumerate all of the iSCSI target portals on the system:
> ASMCLI -enumerateiSCSIPortals
1 iSCSI Target Portals discovered: iSCSI Target Portal: 10.127.63.100 Status: No errors Error:
N/A
ASMCLI -enumerateSmartCopies
The ‑enumerateSmartCopies subcommand enumerates or lists the Smart Copy Sets of a specified component that can be used with
the restore and selective restore commands. This subcommand omits Smart Copy Sets that cannot be used for restore
operations, such as Smart Copies that are unreachable, or in a temporary state (such as having checksum verification in progress).
This subcommand outputs the timestamp for when the Smart Copy set was created, as well as the relative backup document pathname
for each backup document that supports the restore and selective restore commands. A summary line reports the total number
of documents found, and the number of documents that are usable for the restore commands supported for the Smart Copy source
object.
The document pathname can be used for the ‑document parameter of the restore commands. The pathname does not include the
shadows folder portion of the path.
Using the Command Line Interface
113