Users Guide

Remote Setup Wizard Command Line

Interface

The Remote Setup Wizard Command Line Interface (RSWCLI) provides setup commands that you can execute at the Linux command

prompt and a command line interface where you can perform all required setup actions.

Topics:

• General Command Syntax for the RSWCLI

• Configuration — Discovering a PS Series Array

• Initializing a PS Series Array

• Managing Access to a PS Series Group

• Listing Accessible Groups

• Modifying Access to a Group

• Removing Host Access to a Group

• Configuring Multipath I/O

General Command Syntax for the RSWCLI

The general RSWCLI command syntax is as follows:

# rswcli --subcommand | -abbreviated_subcommand [--parameter|

--abbreviated_parameter [argument]]

The following rules apply:

• When spelling out the full subcommand, prefix with a double dash (--). For example, rswcli --list-group.

• Prefix abbreviated subcommands with a dash (‑). For example, rswcli -l.

• When specifying parameters, use a double dash with both full and abbreviated parameter names. For example, --group-name or --

gn.

• Use of the equal sign (=) to specify a value to parameters is optional. For example, --member-name=eqlgroup1 and --member-

name eqlgroup1 are equivalent.

• Brackets ([]) indicate that a parameter or argument is optional.

• Several parameters are mutually exclusive and specifying more than one of these parameters causes the command to fail. The

command parser ignores any redundant parameters.

• To display all applicable parameters, enter an entire subcommand followed by a tab.

• To display a list of applicable options, enter part of any subcommand or parameter followed by two tabs. For information, see Bash

Command Completion.

• To access help on any RSWCLI subcommand, use the --help or -h parameter after specifying the subcommand. For example,

rswcli --discover --help.

Configuration — Discovering a PS Series Array

Use the rswcli --discover (or rswcli -d) command for a list of uninitialized PS Series array serial numbers.

Remote Setup Wizard Command Line Interface 23