Users Guide
Group Name: new31-grp
Group IP Address: 192.xx.xx.xx
The modify-group-access command succeeded.
Removing Host Access to a Group
Use the rswcli --remove-group-access (or rswcli -r) command to remove host access to the PS Series group.
rswcli --remove-group-access Command Syntax
The command syntax is as follows:
rswcli --remove-group-access | -r
--group-name group-name | --gn
The following table describes the required command parameter.
Table 10. Remove Group Access Command Required Parameter
Parameter Abbr. Argument Description
--group-name -gn group-name Designates the name of the PS Series group to which access is to be removed.
Example: Removing Host Access to Group
In the following example, access is removed to the group farm30-grp:
# rswcli –-remove-group-access --gn farm30-grp
Processing remove-group-access command...
The remove-group-access command succeeded.
Configuring Multipath I/O
Several configuration parameters control the behavior of the EqualLogic Host Connection Manager daemon (ehcmd). The rswcli --
mpio-parameters command lets you view and modify the most commonly used multipath I/O parameters. These parameters
determine:
• Number of iSCSI sessions to create to each volume
• Minimum adapter speed to use for iSCSI sessions
• Load balancing policy to set
• IP version to use (IPv4 or IPv6)
For complete information on configuring multipath I/O using the rswcli --mpio-parameters command parameters, see Configuring
Multipath I/O Devices.
Remote Setup Wizard Command Line Interface
29