Setup Guide
B
FS Series Appliance CLI Output Examples
The following sections provide examples of the output displayed when you update the FS Series rmware as described in FS Series
Appliances - Planning and Prerequisites.
Output Displayed When Firmware Is Copied to an Appliance Using FTP
The following example uses FTP to copy a rmware update kit named DellFS-4.0.version-SP.iso from a host to an appliance with the
IP address 192.0.2.21.
530 Please login with USER and PASS.
---------------------------------------------------------------
output from ftping the servicepack to the nodes (using SAN VIP)
---------------------------------------------------------------
[user@sparkperf3 ~]$ ftp 192.0.2.21 44421
Connected to 192.0.2.21.
220-This is system maintenance FTP service
220-======================================
220-
220-Use this service to download diagnostic files and to upload
220-signed service-pack packages.
220-
220
530 Please login with USER and PASS.
KERBEROS_V4 rejected as an authentication type
Name (192.0.2.21:user):
grpadmin
331 Please specify the password.
Password:
230 Login successful.
Remote system type is UNIX.
Using binary mode to transfer files.
ftp>
bin
200 Switching to Binary mode.
ftp> cd servicepack
250 Directory successfully changed.
ftp> put DellFluidFS-4.0.<version>-SP.iso
local: DellFS-4.0.<version>-SP.iso remote: DellFS-4.0.<version>-SP.iso
227 Entering Passive Mode (10,125,176,240,173,151)
150 Ok to send data.
226 File receive OK.
1143122587 bytes sent in 20 seconds (5.7e+04 Kbytes/s)
ftp>
bye
221 Goodbye.
[user@sparkperf3 ~]$
NOTE:
• If you do not change to the servicepack directory, you will not be able to copy the le.
• When you ftp to the SAN VIP, you must use port 44421. A connection refused message is displayed when you use
any other port, as shown in the following example:
------------------------------------------
[user@sparkperf3 ~]$ ftp 192.0.2.21
ftp: connect: Connection refused
ftp> bye
------------------------------------------
28
FS Series Appliance CLI Output Examples