Administrator Guide

NOTE:
• All group members must be active.
• This procedure requires modifying the conguration of third-party products. See the documentation for your switches for
detailed instructions on these tasks.
1. Set the switch ports used by group members to allow both the old and new VLAN IDs.
2. Bridge the old and new VLANs either by modifying switch settings or by creating an untagged access port for each VLAN and
bridging the connections using the appropriate cable.
3. Set the VLAN ID in the group:
a. Click Group → Group Conguration.
b. Click the Advanced tab.
c. In the Network Management panel, enter the new VLAN ID in the VLAN ID eld. The value must be from 0 to 4095.
4. Recongure iSCSI initiators to use the new VLAN ID.
5. Unbridge the old and new VLANs.
6. (Optional) Modify switch ports so that the old VLAN ID is no longer allowed.
Monitor Data Center Bridging Statistics and Conguration
1. Click Group.
2. Expand Members and then select the group member.
3. Click the Network tab.
4. In the IP Conguration panel, select a network interface.
5. The Switch Information section indicates the LLDP state of the switch connected to the interface.
6. In the Activities panel, click DCB Details to open the dialog box.
NOTE: The DCB Details link appears dimmed if the member does not support DCB.
166
About Volumes