Administrator Guide

Title Field Description Shortcut
Auto ll Automatically enters IP addresses based on the next
available addresses after the rst IP address
Alt+T
Clear Deletes NAS cluster IP addresses from the table Alt+L
Controller IP addresses
NAS Controller
IP Address
IP address for each NAS controller. This address is used
for internal maintenance operations. You must specify one
IP address for each NAS controller.
None
Auto ll Automatically enters IP addresses based on the next
virtual IP address
Alt+F
Clear Deletes NAS controller IP addresses from the table. Alt+R
Table 330. Supported NAS Appliance IP Addresses by Bonding Mode
NAS Appliance Model Number of NAS Cluster IP Addresses by Bonding Mode
Adaptive Load Balancing (ALB) LACP IEEE 802.3 (Default)
FS7500 4 per controller 1 per controller
FS7600 4 per controller 1 per controller
FS7500 and FS7600 4 per controller 1 per controller
FS7610 2 per controller 1 per controller
Table 331. Advanced Tab
Field Description Shortcut
Bonding Mode Bonding mode for the client network. The default bonding mode is ALB, which
requires no special switch settings and allows optimal load balancing using fewer
NAS cluster IP addresses. You must stop the NAS cluster before you modify the
bonding mode. Modication can occur only during a Modify operation.
If you modify the client network conguration and change the bonding mode to
LACP, which supports automatic, transparent network interface failover, you must
set special switch settings across the switch stack.
If you change the MTU size, clients are disconnected. In most cases, the clients
reconnect automatically.
Alt+O
MTU Size Size of the maximum transmission unit (MTU) for the client network.
NOTE: You must stop the NAS cluster before you can modify the client
network MTU size.
NOTE: You must set the MTU size to a minimum value of 9000 bytes if you
are using jumbo frames in your client network environment. Otherwise, the
client network defaults to 1500 bytes.
Alt+M
482
Reference: GUI Panels, Wizards, and Dialog Boxes