Install Guide
PS6610 安 装 和 设 置 指 南
5 软件配置
3. 出现提示后,输入 y 以启动 setup 公用程序。
4. 出现提示后,请根据
第
23
页上 收集配置信息
中的信息输入阵列和组配置信息。按 Enter 键以
接受默认值。输入问号 (?) 以获取帮助。
注 :输入组 IP 地址之后可能会有短暂的延迟,因为阵列正在搜索网络以确认未使用该地址。
setup 完成后,必须先设置成员的 RAID 策略才能使用磁盘存储空间。转到
第
26
页上 设置成员的
RAID
策略
。
以下示例显示使用 setup 公用程序初始化阵列并创建组。
示 例 - 使 用 Setup 公 用 程 序
Login: grpadmin
Password: xxxxxxxx
The setup utility establishes the initial network and storage configuration for a storage array
and then configures the array as a member of a new or existing group of arrays.
For help, enter a question mark (?) at a prompt.
Welcome to Group Manager
Copyright 2015 Dell Inc.
It appears that the storage array has not been configured.
Would you like to configure the array now? (y/n) [n] y
Group Manager Setup Utility
Do you want to proceed (yes | no) [no]? yes
Initializing.This may take several minutes to complete.
Enter the network configuration for the array:
Member name []: member1
Network interface [eth0]: eth0
IP address for network interface []: 192.17.2.41
Netmask [255.255.255.0]:
Default gateway [192.17.2.1]:
Enter the name and IP address of the group that the array will join.
Group name []: group1
Group IP address []: 192.17.2.20
Searching to see if the group exists.This may take a few minutes.
The group does not exist or currently cannot be reached.Make sure you have entered the correct
group IP address and group name.
Do you want to create a new group (yes | no) [yes]? yes
Group Configuration
Group Name: group1
Group IP address: 192.17.2.20
Do you want to use the group settings shown above (yes | no) [yes]: yes
Password for managing group membership:
Retype password for verification:
Password for the default group administration account:
Retype password for verification:
Saving the configuration ...
Waiting for configuration to become active......Done
Group member member1 now active in the group.
Group group1 has been created with one member.
Use the Group Manager GUI or CLI to set the RAID policy for the member.You can then create a
volume that a host can connect to using an iSCSI initiator.
group1>
25