Install Guide
PS6610 インストールとセットアップガイド
5 ソフトウェア設定
Default gateway [192.17.2.1]:
Enter the name and IP address of the group that the array will join.
Group name []: group1
Group IP address []: 192.17.2.20
Searching to see if the group exists.This may take a few minutes.
The group does not exist or currently cannot be reached.Make sure you have entered the correct
group IP address and group name.
Do you want to create a new group (yes | no) [yes]?yes
Group Configuration
Group Name: group1
Group IP address: 192.17.2.20
Do you want to use the group settings shown above (yes | no) [yes]: yes
Password for managing group membership:
Retype password for verification:
Password for the default group administration account:
Retype password for verification:
Saving the configuration ...
Waiting for configuration to become active......Done
Group member member1 now active in the group.
Group group1 has been created with one member.
Use the Group Manager GUI or CLI to set the RAID policy for the member.You can then create a
volume that a host can connect to using an iSCSI initiator.
group1>
リモートセットアップウィザードを使 用 したソフトウェアの設 定
リモートセットアップウィザードは『Host Integration Tools』CD-ROM に収録されており(サポートサイトからダウン
ロードすることも可能です)、Windows または Linux コンピュータにインストールする必要があります。『Host
Integration Tools User Guide』(Host Integration Tools ユーザーガイド)には、リモートセットアップウィザードの全機
能の使用に関する詳細情報が記載されています。
リモートセットアップウィザードを実行するには、次の手順に従います。
1. 25 ページの「設定方法の選択」の要件を満たすコンピュータを使用します。
2. 配送ボックスから『Host Integration Tools』CD-ROM を取り出す、またはサポートサイトから『Host Integration
Tools』キットをダウンロードします。
3. 『Host Integration Tools』マニュアルの手順に従って、リモートセットアップウィザードをインストールします。
4. スタート、プログラム、EqualLogic、Remote Setup Wizard(リモートセットアップウィザード)とクリックして、リモー
トセットアップウィザードを起動します。
5. Welcome(ようこそ)ダイアログボックスで、Initialize a PS Series array(PS Series アレイを初期化する)を
選択し、Next(次へ)をクリックします。
メモ: アレイと通信できない場合は、ネットワーク設定を確認してください。setup ユーティリティを使用したソ
フトウェアの設定が必要になる場合もあります。
6. 初期化するアレイを選択し、Next(次へ)をクリックします。
7. Initialize Array(アレイの初期化)ダイアログボックスで、表 8 のアレイ設定を入力し、グループを作成するか
既存のグループに追加するかを選択します。Next(次へ)をクリックします
8. Create a New Group(新規グループの作成)ダイアログボックスまたは Join an Existing Group(既存のグループ
への追加)ダイアログボックスで、表 9 からグループ設定を入力し、Next(次へ)をクリックします。
9. Finish(終了)をクリックしてウィザードを終了します。
28