Service manual

4. At the startup screen, select True Image Server OEM (Full Version).
The Acronis main window appears.
5. In the Acronis main window, click Recovery.
The Restore Data Wizard opens.
6. On the Welcome page, click Next.
7. On the Backup Archive Selection page, in the tree view expand the node for the E: partition and
select the image le, then click Next.
8. On the Restoration Type Selection page, select Restore disks or partitions and then click Next.
9. On the Partition or Disk to Restore page, select (C:) and then click Next.
10. On the Restored Partition Location page, select (C:) and then click Next.
11. On the Restored Partition Type page, leave the selection at Active and then click Next.
12. On the Restored Partition Size page, leave settings at their defaults. The size reported in the upper
pane is the size detected of the actual C: partition. This should be the same as that reported in
the Partition size eld in the middle of the page. Free space before and Free space after should
both be reported at 0 bytes. Click Next.
13. On the Next Selection page, depending on the partitions you are restoring, do one of the following:
If you are restoring only the C: partition, select No, I do not and then click Next.
Skip ahead to the “…ready to proceed…” page in step 20.
If you are also restoring the D: partition, select Yes, I want to restore another partition or hard
disk drive and then click Next.
Continue with the next step in this procedure.
14. On the Partition or Disk to Restore page, select (D:) and then click Next.
15. On the Restored Partition Location page, select (D:) and then click Next.
opens.
16. On the Restored Partition Type page, leave the selection at Primary and then click Next.
17. On the Restored Partition Size page, leave settings at their defaults. The size reported in the upper
pane is the size detected of the actual D: partition. This should be the same as that reported in
the Partition size eld in the middle of the page. Free space before and Free space after should
both be reported at 0 bytes. Click Next.
18. On the Next Selection page, select No, I do not and then click Next.
19. On the Restoration Options page, do not make any selections. Click Next.
20. On the “…ready to proceed…” page, verify that you are restoring the correct image to the correct
location. Click Proceed.
21. On the Operation Progress page, observe the progress report.
22. When a message appears indicating a successful recovery, click OK.
23. Click Operations | Exit to exit the Acronis True Image program.
The machine restarts automatically.
24. Remove the recovery media while the machine is shutting down.
2013 07 20 K2 Installation and Service Manual 109
Managing K2 Software