Service manual

The backup consists of a directory and multiple les. Keep all les and directories intact. Do not
delete or separate.
Restoring from the system-specific recovery disk image on E: Dell R620
Use this task to restore a server using an image made from that particular server. If restoring from
a generic factory default image, do not use this task.
1. Make sure that media access is stopped and that the system on which you are working is not
being used.
2. Connect all motherboard NICs to LAN connections.
3. If you have not already done so, connect keyboard, monitor, and mouse.
4. Do the following:
a) Insert the Recovery CD.
b) Restart the machine.
If there is a problem restarting, hold the standby button down for ve seconds to force a hard
shutdown. Then press the standby button again to startup.
The system boots from the Recovery CD.
The Acronis program loads.
5. On the Acronis Rescue Media page, select Acronis Backup and Recovery 11.5 (64-bit...)
The Acronis Backup and Recovery page opens.
6. On the Acronis Backup and Recovery page, select Recover.
The Recover Data page opens
7. On the Recover Data page, under What to Recover page, select Select Data.
The Data to Recover Selection dialog box opens.
8. On the Data to Recover Selection dialog box, do the following:
a) Select Browse.
b) In the tree view, expand the Local Folders node.
c) Select the E drive.
Even though your backup is on the E drive, it is not yet visible.
d) Click OK.
On the Archive View tab, your backup name is listed.
9. On the Archive View tab, select your backup.
10. Under Backup contents, do the following:
a) Select C: and D:.
b) Click OK.
The Data to Recover Selection dialog box closes.
2013 07 20 K2 Installation and Service Manual 113
Managing K2 Software