Service manual

11. On the Recover data page, under Where to recover, verify the following:
Physical machineRecover to:
Clear all
Properties....Size:.......Letter: CRecover 'NTFS (C:)' to...
Clear Disk 1/NTFS (C:)
Properties....Size:.......Letter: DRecover 'NTFS (D:)' to...
Clear Disk 1/NTFS (D:)
12. On the Recover Data page, click OK.
The restore process begins.
13. On the My Recovery Details page, select the Progress tab to view the progress.
The image loads in approximately 9 minutes.
14. When the data is successfully restored, click OK.
15. Close all Acronis pages and the Acronis main window.
The machine restarts automatically.
16. Remove the recovery media while the machine is shutting down.
Restoring from a generic recovery disk image Dell R620
This task restores a server to its factory default state. For example, if you neglected to make a rst
birthday image, you might need to use this procedure. If the image from which you are restoring
was made from the same, specic machine to which it is being restored, do not use this task.
NOTE: This procedure restores the server (C:, D:, and E: partitions) to its factory default
condition. Passwords and other site-specic congurations are reset to factory defaults.
1. Make sure that media access is stopped and that the system on which you are working is not
being used.
2. Connect all motherboard NICs to LAN connections.
3. If you have not already done so, connect keyboard, monitor, and mouse.
4. Do the following:
a) Insert the Recovery CD.
b) Restart the machine.
If there is a problem restarting, hold the standby button down for ve seconds to force a hard
shutdown. Then press the standby button again to startup.
The system boots from the Recovery CD.
The Acronis program loads.
5. On the Acronis Rescue Media page, select Acronis Backup and Recovery 11.5 (64-bit...)
The Acronis Backup and Recovery page opens.
6. On the Acronis Backup and Recovery page, select Recover.
The Recover Data page opens
114 K2 Installation and Service Manual 2013 07 20
Managing K2 Software