Service manual

7. On the Recover Data page, under What to Recover page, select Select Data.
The Data to Recover Selection dialog box opens.
8. On the Data to Recover Selection dialog box, do the following:
a) Select Browse.
b) In the tree view, select the USB drive that contains the generic recovery disk image.
Even though your backup is on the drive, it is not yet visible.
c) Click OK.
On the Archive View tab, your backup name is listed.
9. On the Archive View tab, select your backup.
10. Under Backup contents, do the following:
a) Select MBR.
b) Select C:, D:, and E:.
c) Click OK.
The Data to Recover Selection dialog box closes.
11. On the Recover data page, under Where to recover, select the correct destination partition for
each source partition as follows:
a) Select Recover Disk 1 MBR.
The MBR Destination dialog box opens.
b) In the MBR Destination dialog box, select Disk 1: Dell PERC ..., as appropriate for the particular
Dell platform. The following are valid selections:
• Disk 1: Dell PERC H710 SCSI
• Disk 1 : Dell PERC H310 SCSI
c) Click OK.
d) Select Recover NTFS (C:).
The Volume Selection dialog box opens.
e) In the Volume Selection dialog box, select C.
f) Click OK.
g) Select Recover NTFS (D:).
The Volume Selection dialog box opens.
h) In the Volume Selection dialog box, select D.
i) Click OK.
j) Select Recover NTFS (E:).
The Volume Selection dialog box opens.
k) In the Volume Selection dialog box, select E.
l) Click OK.
12. On the Recover Data page, click OK.
The restore process begins.
13. On the My Recovery Details page, select the Progress tab to view the progress.
The image loads in approximately 9 minutes.
2013 07 20 K2 Installation and Service Manual 115
Managing K2 Software