Service manual

Configure Network Configuration page - Redundant K2 SAN server A and server B
This page displays the control network Ethernet port, and allows you to congure the FTP/Streaming
network Ethernet port.
NOTE: This page does not congure the iSCSI interface (media network) ports.
1. Verify that the top port is congured correctly.
The top port is the port over which the K2Cong application is communicating. If correctly
congured, it is already assigned the control network IP address, as displayed on this page.
2. If the server has the role of FTP server, verify that the other port is congured correctly. If not
congured correctly, do the following:
a) Select the other port and click Modify.
A network conguration dialog box opens.
b) Enter the FTP/Streaming IP address and the subnet mask and click Apply.
For systems with an optional NH (FTP) server, the server you are now conguring does not take
the role of FTP server, so conguring the second port here for the FTP/streaming network is not
required.
3. Click Next.
The File System Server Conguration page opens.
170 K2 Installation and Service Manual 2013 07 20
Conguring and licensing the K2 SAN