Service manual
Check the V: drive
Prerequisites:
• The K2 Media Server is congured
• The restart of the K2 Media Server after it is congured is complete
This task is required for NAS server functionality.
1. Verify that the K2 Media Server has restarted by opening the MS-DOS command prompt and
use the “ping” command.
2. In the K2Cong application tree view, under the K2 Media Server select the File System Server
node.
The File System Server Conguration page appears.
3. Click Check and verify that the V: drive is shared.
The K2 Nearline SAN conguration is complete.
Configuring the redundant nearline K2 SAN
Work through the topics in this section sequentially to congure a redundant nearline (Tier 3) K2
SAN.
Prerequisites for initial configuration - Nearline K2 SAN
Before beginning your initial conguration, make sure the devices of the K2 SAN meet the following
prerequisites.
Control point PC
• Ethernet cable connected
• Control Point software installed
• Control network IP address assigned
• Network communication over the control network with all other K2 devices
• Power on
Ethernet switch
• Ethernet cables connected
• Control network IP address assigned
• VLANs set up
• Trunks set up
• Power on
2013 07 20 K2 Installation and Service Manual 199
Conguring and licensing the K2 SAN