Service manual

3. In the K2Cong application tree view, verify that the K2 SAN has the correct number of clients,
according to your system design.
If the correct number of clients is not currently added to the K2 SAN, you can add or remove
clients now (before clients are congured), as follows:
• To add a client, select the top node of the storage system and click the Add Device button.
• To remove a client, select an uncongured client and click the Remove button.
4. In the K2Cong application tree view, select the system you are adding to the K2 SAN.
5. Select a client and click the Configure button.
The conguration wizard opens to page 1.
NOTE: If your system has a large number of iSCSI clients, you are prompted to restart the server
that has the role of SNFS le system server when you congure clients and cross the following
thresholds: 64 clients; 80 clients; 96 clients.
Configure page 1 - K2 client
1. Enter the IP address or network name for a SAN client, as currently congured on the client
system.
You should congure your highest bandwidth SAN clients rst, as this ensures load balancing
is correct.
2. For the Storage Access settings, leave iSCSI selected.
3. Click Next.
The Software Conguration page opens.
2013 07 20 K2 Installation and Service Manual 227
Conguring clients on the K2 SAN