Service manual

Configure File System Client Configuration page
This page connects the SAN client as a media le system client to the K2 Media Server taking the
role of media le system server. If there are redundant K2 Media Servers, both are listed on this
page as le system servers.
1. Verify that the K2 client is connecting to the correct K2 Media Server or Servers, as follows:
• For a basic (non-redundant) K2 SAN, the client connects to the only server.
• For a redundant K2 SAN, the client connects to server A as le system server 1 and server
B as le system server 2.
2. Click Check.
3. When the wizard reports that the conguration check is successful, click Next.
Repeat these tasks to add remaining SAN clients to the K2 SAN.
Adding a generic client device
Prerequisites for adding a generic client to an existing K2 SAN are as follows:
• You must be logged in to the K2Cong application with permissions equivalent to K2
administrator or higher.
• The devices of the K2 SAN do not need to be ofine, and there is no restart of devices required.
1. In SiteCong, add the client device to the appropriate group and verify that it is communicating
correctly on networks.
2. In the K2Cong application tree view, select the name of the K2 SAN, which is the top node of
the storage system tree.
2013 07 20 K2 Installation and Service Manual 233
Conguring clients on the K2 SAN