Service manual

Renaming a K2 SAN
Prerequisites for renaming an existing K2 SAN are as follows:
• You must be logged in to the K2 System Conguration application with permissions equivalent
to K2 administrator or higher.
• The devices of the K2 SAN do not need to be ofine, and there is no restart of devices required.
1. In the K2 System Conguration application tree view, select the current name of the K2 SAN,
which is the top node of the storage system tree.
2. Click Rename. The Rename dialog box opens.
3. Enter the new name of the SAN and click Apply.
4. If the SAN name is used similarly in SiteCong, make the appropriate change in SiteCong.
Adding devices to a K2 SAN
Refer to the topics in this section to add devices to an existing K2 SAN.
Adding a generic client device
Prerequisites for adding a generic client to an existing K2 SAN are as follows:
• You must be logged in to the K2Cong application with permissions equivalent to K2
administrator or higher.
• The devices of the K2 SAN do not need to be ofine, and there is no restart of devices required.
1. In SiteCong, add the client device to the appropriate group and verify that it is communicating
correctly on networks.
2. In the K2Cong application tree view, select the name of the K2 SAN, which is the top node of
the storage system tree.
3. Click Add Device. The Add Device dialog box opens.
4. Select the type of client you are adding.
5. Click OK. The new client appears in the tree view.
6. Congure the client as appropriate. Refer to the documentation for the device.
Enter the RVIO value as provided by Grass Valley. Do not attempt to calculate the RVIO value
on your own.
When conguring editors on a K2 SAN with 1 Gig TOEs, do not assign editors and K2 clients
(K2 Summit or K2 Media Client) to the same TOE. Instead, assign editors to their own TOE.
Adding an Ethernet switch
Prerequisites for adding a Gigabit Ethernet switch to an existing K2 SAN are as follows:
• You must be logged in to the K2 System Conguration application with permissions equivalent
to K2 administrator or higher.
• The devices of the K2 SAN do not need to be ofine, and there is no restart of devices required.
1. In SiteCong, add the switch to the appropriate group.
2013 07 20 K2 Installation and Service Manual 271
Administering and maintaining the K2 SAN