Service manual

4. Reconcile the locations assigned to the adapter names with the names as currently congured in
the Name column as follows:
• On systems with no 10 Gig network interface card installed, the required mapping of names
to locations is specied as follows:
Must be named as follows:The adapter name (as displayed in the Device
Name column) that is assigned to this
location…
Control ConnectionPCI bus 1, device 0, function 0
FTP-Streaming ConnectionPCI bus 1, device 0, function 1
Unused Connection 1PCI bus 2, device 0, function 0
Unused Connection 2PCI bus 2, device 0, function 1
• On systems with a 10 Gig network interface card installed, the required mapping of names
to locations is specied as follows:
Must be named as follows:The adapter name (as displayed in the Device
Name column) that is assigned to this
location…
Control ConnectionPCI bus 1, device 0, function 0
Unused Connection 0PCI bus 1, device 0, function 1
Unused Connection 1PCI bus 2, device 0, function 0
Unused Connection 2PCI bus 2, device 0, function 1
FTP 10G ConnectionPCI bus 5, device 0, function 0
The 10 Gig network interface adapter must be named FTP 10G Connection. If it has
dual-ports, name the other connection Unused Connection 3 10G.
5. Proceed as follows:
• If all the names on this system are congured correctly to locations, skip the rest of this
procedure.
• If names on this system are not congured correctly to locations, for each adapter name
incorrectly congured, complete the remaining steps of this procedure.
6. Select the name in the Name column.
7. Select File | Rename to enter rename mode.
8. Type the name required for the location.
Next, reorder adapters.
Reorder adapters
Before beginning this task, make sure of the following:
• Adapters are named correctly according to their PCI bus location
• The control team is created
286 K2 Installation and Service Manual 2013 07 20
Administering and maintaining the K2 SAN