Service manual

• The team and loopback are named
1. If not already open, open Network Connections as follows:
a) Open the Windows Network and Sharing Center control panel.
b) Click Change Adapter Settings.
Network Connections opens.
2. Select Advanced, then Advanced Settings…
3. On the Adapters and Bindings tab, order adapters as follows:
• On systems with no 10 Gig network interface card installed, the specied order is as follows
Control Connection
FTP-Streaming Connection
Unused Connection 1
Unused Connection 2
• On systems with a 10 Gig network interface card installed, the specied order is as follows
Control Connection
FTP 10G Connection
Unused Connection 1
Unused Connection 2
Unused Connection 3 10G
4. Click OK to close and accept the changes.
5. Close Network Connections.
If continuing with network conguration, next set power management settings.
Set power management settings
1. If not already open, open Network Connections as follows:
a) Open the Windows Network and Sharing Center control panel.
b) Click Change Adapter Settings.
Network Connections opens.
2. Right-click one of the adapters and select Properties.
The Properties dialog box opens.
3. Click Configure.
4. On the Power Management tab, uncheck all checkboxes, if they are not already unchecked.
5. Click OK.
6. If a “…lose connectivity…” message opens, click Yes.
7. Repeat these steps on the remaining network connection in the Network Connections window.
2013 07 20 K2 Installation and Service Manual 287
Administering and maintaining the K2 SAN