Service manual
2. In Storage Utility, right-click a controller in the tree view, then do one of the following:
• To load controller microcode select Advanced | Load Controller Microcode
• To load expansion chassis microcode select Advanced | Load Disk Enclosure Microcode
Redundant controllers that share the same set of disks are automatically selected and upgraded
as a pair.
The Login Information dialog box opens.
3. If necessary, enable elds and enter username, password, or controller IP address, then click OK.
The Load Firmware wizard opens.
322 K2 Installation and Service Manual 2013 07 20
Administering and maintaining the K2 SAN