Service manual

Preparing for installation
K2 SAN installation checklists
Use the following sequence of checklists to guide the overall task ow of installing and
commissioning a K2 SAN.
Pre-installation planning checklist
CommentInstructionsTask
You can do this before
arriving at the customer site.
About developing a system
description on page 73
Procure existing or create new
SiteCong system description
Next: Infrastructure checklist
Infrastructure checklist
CommentInstructionsTask
—
Cabling K2 SAN devices
Rack and cable
—
Setting up the Ethernet switch
on page 57
Congure Ethernet switch(es)
—
Install SiteCong on control
point PC on page 70
Install/update SiteCong on
control point PC
Next: Network setup and implementation checklist
Network setup and implementation checklist
CommentInstructionsTask
Select IP address range for
each network and each device
type.
Importing a system description
on page 73
Import or create the
SiteCong system description
on the control point PC
Set subnet mask and other
settings.
Modifying a device name on
page 74, Modifying the
control network on page 74,
Modifying the FTP/streaming
network on page 76,
Modifying a media (iSCSI)
network on page 78
Modify names and networks
in the SiteCong system
description.
2013 07 20 K2 Installation and Service Manual 37