Service manual

Cable K2 RAID
Before cabling, install the K2 RAID chassis in its permanent location. After mounting the chassis
in the rack, you must secure brackets to the front rail to support the Grass Valley bezel. Refer to
related topics in this document for rack mount instructions.
You do not need to manually set a Fibre Channel address ID on controllers or a chassis address on
Expansion chassis.
As directed by the system diagram for your storage system, cable the K2 RAID devices using the
instructions in this section.
Once the RAID storage is connected and congured, do not swap Expansion chassis or otherwise
recongure storage. If you connect an Expansion chassis in a different order or to the wrong
controller, the controller will see a conguration mismatch and fault.
K2 RAID basic online/production
These cabling instructions apply to the following:
• K2 10Gv2 RAID on a basic (non-redundant) online or production K2 SAN.
AC DCAC
1
0
DC
ENC ID
ENC ID/DIAG
ID
1
0
ENC ID
ENC ID/DIAG
ID
Continue this cable pattern for additional Expansion Chassis.
K2 RAID redundant online/production
These cabling instructions apply to the following:
• K2 10Gv2 RAID on a redundant online or production K2 SAN.
2013 07 20 K2 Installation and Service Manual 53
Cabling K2 SAN devices