Service manual
The networks listed in the Edit IP Address dialog box are those currently dened in the system
description, with available settings restricted according to the network denition. If you
require settings that are not available, you can close dialog boxes and go to the Network
Configuration | Networks tab to modify network settings, then return to the Edit IP Address
dialog box to continue.
9. When you have veried that the planned settings are correct, click OK, then Yes to apply settings
to the device and close.
A Contacting Device message box reports progress.
10. After conguring control network settings, do the following
a) If a message informs you of a possible loss of communication, click OK.
This message is normal, since this is the network over which you are currently communicating.
b) In the Device list view, observe the device icon and wait until the icon displays the green star
overlay before proceeding.
The icon might not display the green star overlay for several seconds as settings are
recongured and communication is re-established.
c) In the Interface list view, right-click the interface and select Ping.
The Ping Host dialog box opens.
If ping status reports success, the interface is communicating on the control network.
Modifying K2 Media Server managed network interfaces
Prerequisites for this task are as follows:
• The physical device you are conguring has been discovered and is assigned to a device in the
SiteCong system description.
• SiteCong has communication with the device.
• The device is dened in the system description with an appropriate network interface.
Use this task to modify managed network interfaces on a K2 SAN device as follows:
• K2 Media Server
2013 07 20 K2 Installation and Service Manual 93
Planning and implementing a K2 SAN with SiteCong