Service manual

• NH K2 Media Server
1. In the Interfaces list view determine the interface to congure, as follows:
• Identify the interface with which SiteCong is currently communicating, indicated by the
green star overlay icon. This should be the control network interface.
• Verify that the interface over which SiteCong is currently communicating is in fact the
interface dened for the control network in the system description. If this is not the case, you
might have the control network cable connected to the wrong interface port. The control
connection should always be the rst port on the motherboard, except when you have a
loopback connection.
• Congure the control network interface rst before conguring any of the other interfaces.
• After you have successfully congured the control network interface, return to this step to
congure each remaining interface.
• For the K2 Media Server, do not congure the Fibre Channel interface, which is a non-IP
interface. SiteCong does not manage this interface. It is represented in SiteCong only to
complete the description of the K2 Media Server.
2. In the Interfaces list view, check the icon for the interface you are conguring.
If the icon has a red stop sign overlay, it indicates that current settings and planned settings do
not match or that there is some other problem. Hover over the icon to read a tooltip with
information about the problem.
94 K2 Installation and Service Manual 2013 07 20
Planning and implementing a K2 SAN with SiteCong