Operator's Guide Imprinter fi-565PR

6 |

HINT

How to remove the Attachment Guide

Pressing your fingers on the Attachment Guide,

slide it down and out to remove.

5. Remove the attached screw from the Imprinter’s

rear portion.

6. Install the Imprinter to the Scanner.

To install the Imprinter to the scanner, insert the

connecting pins located on the Scanner’s rear

component into the scanner’s round holes.

ATTENTION

● Do not hold the imprinter cover when carrying

or transferring it from one place to another.

● Attach the imprinter firmly on to the scanner.

(ÆConfirm that the Imprinter does not

separate from the Scanner when pulled.)

● Be careful not to pinch your fingers.

7. Attach the Screw to fix the Imprinter. (1 position)

8. Connect the EXT Cable to the Scanner‘s rear

connector.

ATTENTION

The Imprinter will not work if the EXT cable is

not connected to the Scanner. Scanning when

the EXT cable is not connected can cause

documents to jam inside the Imprinter.

9. Replace the black cover (

removed in procedure 3

)

to the Imprinter.

c Place the hollows at the cover’s bottom into the

projecting side-points inside of the imprinter.

d Close the cover until it snaps in place.

Screw

EXT Cable

After installation

Connectin